Male Genital Waxing Philadelphia

Top rosa tg 40

Here, dear friends, a cute point that you can exploit, not only to achieve this top but, also, lengthening the processing to a fine robes or ... for a shirt or whatever.

However, we are at the top.

Needed:

- 100g of pink cotton crochet

-No 3.50

-knitting needle with a rounded tip

Points used:

low-knit-crochet

-half treble

-top high-point

petals (which is working on a number of links multiple of 9) for the implementation, follow the diagram in mind:

-petal: sull'uncinetto throw line, aim the 'crochet nell'archetto basic, pull the wire and extend it slightly to a height equal to a treble, throw back the wire sull'uncinetto, point the bow hook in the same basic, pull the thread again, stretch it slightly, discard the wire mesh and close the first 4, Disposable new thread and close the last link.

Design:

The top is worked in one piece in circles until the shortages, and then continue in rounds of return.

Start a chain of 144 links, with a close-loop m.bss. the first cat. and the piping work around a half m.alta, close with a m.bss.

p.petali Continue following the diagram.

At 20 cm from the edge (less than 26 laps) to achieve the sleeve holes and the cup go on line and return to continue only on the 8 following reasons (ie the 8 groups of 3 to its petals and 7 groups of 3 ch 2 suspension. between groups of petals) to suspend processing sides on a plea, then on each line, half a reason for 2 times.

At the same time, after two lines (at the beginning of the sleeve holes 1.5 cm), and for the neck to form the cups, suspend lalvorazione on three central motifs (corresponding to 2 groups of 3 petals and its 3 groups of 2 bows 3 cat.) and completed the two parts separately suspend still working towards the center of each line, half a reason to stay with a bow cat 3, and a group of 3 petali. Nella riga seguente lavorare 3.cat, saltare il 1° petalo, 1 m.a. nello spazio tra 2 petali, 2 cat., 1 m.a. nell'ultima m. della riga prec.; voltare, 3 cat., 1 m.a. nell'ultima m. della riga prec.

Spezzare il filo.

Spalline:

avviare una cat. di 5 m. e, a partire dalla 4a cat. dall'uncinetto, lav. 1 m.a. in ciascuna delle 2 cat. seg. (=3 m.a.). Proseguire a m. a. iniziando ogni r. con 3 cat. che sono la 1a m.a.

A 25 cm di alt. tot. spezzare e fermare il filo.

Eseguire 2 spalline uguali.

Rifiniture:

Rifinire gli scalfi, i margini delle coppe e il margine superiore dietro e davanti eseguendo 2 giri a mezza m.alta. Rifinire il fondo dietro e davanti con 1 giro a mezza m.alta. Fissare un'estremità delle spalline alla sommità delle coppe e l'altra estremità al margine superiore del dietro centrandole a 22 cm di distanza tra di loro.